The Setup—>Network configuration page allows you to view and update the routing information on the jetNEXUS ALB-X. The settings are organised in the following sections:
This is the address of the Firewall or Router that the ALB-X will send traffic to if it does not match any other routes in the routing table. Add the IP address of the Gateway and choose an interface from the drop down box. When you click update, a green tick will appear if the gateway can be reached. A red cross will appear if the gateway cannot be reached.
You can manually add routes for specific subnets in this section.
Enter the destination network address in decimal dotted notation. Example 184.108.40.206
Enter the gateway IPv4 address in decimal dotted notation. Example 10.4.8.1
Enter the destination subnet mask in decimal dotted notation. Example 255.255.255.0
Enter the adapter that the gateway can be reached on. Example eth1.
A green tick box will indicate that the gateway can be reached. A red cross will indicate that the gateway cannot be reach on that interface. Please make sure you have set up an interface and IP address on the same network as the gateway