Appliance

Appliance

The Setup–>Appliance section allows you view and update the
network details of your jetNEXUS ALB-X load balancer. It is organised
into the following sections. 

Adapter Details

Here you can add, remove and update the adapter settings.

Adapter:

Double click to see the
physical adapters installed on your appliance. Choose an adapter from the list


VLAN:

Double
click to add the VLAN ID for the adapter. A VLAN is a Virtual Local
Area Network which creates a distinct broadcast domain. A VLAN has the
same attributes as physical LAN but it allows for end stations to be
grouped together more easily if they are not on the same network switch


IP Address:

Double
click to add the IP address associated with the adapter
interface.
You can add multiple IP addresses to the same interface. This should be an IPv4 32-bit number in quad dotted decimal notation.
Example: 192.168.101.2


Subnet Mask
:

Double
click to add the subnet mask assigned to the adapter interface. This
should be an IPv4 32-bit number in quad dotted decimal notation.
Example: 255.255.255.0


Gateway:

Add a gateway for the interface. When
this is added the ALB-X will set-up a simply policy that will allow
connections initiated from this interface to be returned via this
interface to the gateway router specified. This allows the ALB-X to be
installed in more complex networking environments without the hassle of
manually configuring complex policy based routing


Description:

Double click to add a
description for your adapter. Example: Public Interface. Note: The ALB-X will automatically name the first interface Green Side, the second interface Red Side and the third interface Side 3 etc. Please feel free to change these naming conventions to your own choice

 
Web Console
:

Double
click the column then tick the box to assign the interface as the
management address for the Graphical User Interface Web Console.
Please be very careful when changing the interface that Web Console
will listen on. You will need to have the correct routing set up or be
in the same subnet as the new interface in order to reach the Web
Console after the change. The only way to change this back is to access
the command line and issue the set greenside command. This will delete all interfaces except for eth0

Appliance

Basic Setup:

ALB Name:

Add in a name for your
jetNEXUS ALB-X appliance. Please note that this cannot be changed
if there are more than 1 member in the Cluster. Please see Clustering


DNS Server:

Add in the IPv4 address of
your DNS server




Advanced Network Setting
:


Server Nagle
:

Tick
the box to enable. This is a means to improve efficiency of TCP/IP
networks by reducing the number of packets that need to be sent over
the network


Client Nagle
:

Tick the box to enable

CONTACT US

We're not around right now. But you can send us an email and we'll get back to you, asap.

Sending

Log in with your credentials

or    

Forgot your details?